John,
Phil Marino modifies your pulley by drilling it to accept the tapered
shaft. The same wide belt is used. He removes the grease nipple and
inserts a plug as the new bearings are "lubed for life". Everything else
appears the same except that the drip is missing.
Bob
On Tue, 30 May 2006 12:18:37 -0400 (GMT-04:00) John Quilter
<jquilter@peoplepc.com> writes:
> Just to clarify. The Marino pump conversion requires a new water
> pump pulley but do you use the same
> belt as before? What is different about the stock pulley and the
> Marino conversion?
>
> John Quilter
> Brisbane, CA
> 51 TD
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|