Re: Next Problem...

[Dave & Liz DuBois <ddubois@sinclair.net>]

Bob,

>I finally got to looking at Ron Francis site and found the SW32
>switch.   It is described as 1/8 pipe thread.  Is that compatible with
>the TDs threads?  
>

Yes, they are compatible, just use some teflon thread tape (make sure 
that it doesn't lap over the hole in the end) or some thread dope on 
threads of the switch.

Dave

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-t