Bud,
The fuel warning lights were originally 2.5 volts and they had a
resistor in the for of wrapped nichrome wire wound around the outside of
the socket. I added an additional resistor on mine to cut down the
brightness of the light, which I found a pain at night. I don't see any
reason that the resistance winding couldn't be bypassed and a 12 volt
bulb used in place of the 2.5 volt bulb. The 2.5 volt bulbs are a bit
hard to find, although Moss or Abingdon should carry them as they are
available, they just have to be special ordered.
Good luck,
Dave
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|