In a message dated 2/28/04 18:17:38 Pacific Standard Time,
gregg.smith@worldnet.att.net writes:
<< Any suggestions? >>
Gregg, for some reason White Post who sleeves with brass does not recommend
silicone with their sleeved cylinders. If the ID of the sleeve is less than
original this could be your problem too. Also you should take .050 off the
face
of the piston to all a little more clearance for the bleed back hole to open
with silicone....silicone is not as slippery as glycol. I have silicone in
all my cars but with the TA I had to put the old rubbers back on the M/C to get
it to work.
Terry in Oakland
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|