can you put a spacer between caliper halves it it is a 2 piece caliper? If
they are just barely touching and you can rotate the wheel i doubt if you
need a total of 1/8 inch more clearance though probably less than that total
which begs the question van you have the rotor turned a tiny bit so you can
use standard pads in the future. If the wheel turns by hand I suspect you
need maybe 0.01 to a max of 0.02
Dave
> -----Original Message-----
> From: owner-land-speed@autox.team.net
> [mailto:owner-land-speed@autox.team.net]On Behalf Of Ron Gibson
> Sent: Monday, May 23, 2005 12:04 AM
> To: atrav; LSR list
> Subject: Re: Brake pad material removal
>
>
> As soft as brake pads are, I would just lay an 80 grit piece of
> sandpaper
> on a flat surface and run the pad over it. You might use a finer one to
> smooth it, but I see no problem if you just let them seat themselves. Some
> new ones have a rough surface.
>
> Ron
>
>
> >
> > I need to remove about a 1/16" of brake pad material from each
> pad, what's
> a good way to do that?
> >
> > TIA,
> > -Aron-
|