As soft as brake pads are, I would just lay an 80 grit piece of sandpaper
on a flat surface and run the pad over it. You might use a finer one to
smooth it, but I see no problem if you just let them seat themselves. Some
new ones have a rough surface.
Ron
>
> I need to remove about a 1/16" of brake pad material from each pad, what's
a good way to do that?
>
> TIA,
> -Aron-
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.322 / Virus Database: 266.11.15 - Release Date: 5/22/05
|