In a message dated 4/14/03 9:04:23 AM Central Daylight Time,
richk@spartajunction.com writes:
<<
I also remember mention of a cheap pipe fitting that could be used
rather than buying specially machined bungs. Couldn't find that either.
RichK
Rich you could go to any plumbing warehouse and buy pipe couplings and cut
them in half and make two out of each one. I would buy steel and not the
malleable they would weld better.
Larry Mac
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|