Each Sensor has a given location based on the manufacture's recommendation
so you might be getting a bit ahead of yourself on this one unless you know
exactly which system your going to use.
As for the cheap bungs.... I took a 7/8" hole saw and drilled through 1/8th
inch plate and used the plugs as the bungs.. Just taped the centering
drill area out and away I went..... works just fine and I can't think of
much any cheaper then that...
K
----- Original Message -----
From: "Richard Kensicki" <richk@spartajunction.com>
To: <land-speed@autox.team.net>
Sent: Monday, April 14, 2003 8:36 AM
Subject: And now, A real LSR question
> So the headers are pulled and laying on the floor since the engine's
> coming out this week. I realize I can weld on bungs for EGT sensors. I
> may never use them, but it's an easy time to do it. Might as well put in
> 8, but where on the pipe? Is 1-2 inches from the exhaust flange too
> close? Would be pretty convenient for access. I searched the archive for
> any mention on location but didn't find what I wanted.
>
> I also remember mention of a cheap pipe fitting that could be used
> rather than buying specially machined bungs. Couldn't find that either.
>
> RichK
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|