A wire brush end and a good eye works pretty easy..
Dave
Keith Turk wrote:
>
> Hey guys speaking of metal.... how was the old Engine turned aluminum or
> stainless actually done?
>
> what did they use to create the swirls? and how do you think they indexed
> it to get the patterns right?
>
> I know it sounds like a stupid question.... but I honestly don't know and
> it was used a bunch on older cars and I even seem to remember some old
> Bonneville cars with Engine turned stuff on them.....
>
> Just an odd ball question
>
> Keith...
> ----------
> > From: Dave Dahlgren <ddahlgren@snet.net>
> > To: JERRY FOSTER <fosterap@flash.net>
> > Cc: LSR Group <land-speed@autox.team.net>
> > Subject: Re: Metal the easy way
> > Date: Wednesday, March 28, 2001 11:11 AM
> >
> > You might want to try http://www.yarde.com and look in the
> > drop zone for cutoffs at substantial savings. I looked at
> > the link below and they are charging 3 times the going rate
> > for 6061 aluminum. I buy lots of it and it should be about
> > 2.25 a pound and they are charging 6.33 a pound..
> > Dave Dahlgren
> >
> > JERRY FOSTER wrote:
> > >
> > > List, I just ordered some metal pieces, and it occured to me that
> everyone
> > > might not be aware of this service.
> > >
> > > There are a number of companies around the country specializing in
> small order
> > > metal stuff like rounds, flats, drill rod, tubing etc. They cut to
> size, so
> > > if you need six pieces of roll cage tubing 14" long, order it that way,
> no
> > > problem. Most have steel, aluminum, stainless, bearing bronze, you
> name it.
> > >
> > > I use a local outfit for faster UPS, but they are all over. A good
> outfit
> > > with an online catalog can be found at http://metalmart.com
> > >
> > > Jerry in Dallas (planning my weekend)
///
/// land-speed@autox.team.net mailing list
///
|