I think they have made these commercially for 20 or so
years.. Try JC Whitney or summit ...
Dave
ardunbill@webtv.net wrote:
>
> Hi Folks, working along on my Ardun, and it occurred to me that I might
> do some Good by putting a powerful magnet in the drain plug on the oil
> pan, while I have a chance. Such magnets are available from Reid and
> others. I note that GM has one on my four-speed drain plug, and Ford
> has one on my 9" axle drain plug.
>
> I have observed that when you start up a fresh engine a lot of cast iron
> dust shows up in the oil (which should of course be dumped promptly)
> from, I imagine, mainly the cylinder bores. Normally this has to go
> through and polish up your oil pump, even if you have a full flow
> filter, which I don't. And, a ton of it lies in the pan, regardless of
> changing your oil. So maybe a really strong magnet in the drainplug
> might just grab all this and hold it.
>
> Anybody see anything wrong with this logic, assuming one can really
> secure the magnet to the drain plug, so it doesn't decide to jump up on
> the crank and then get slung through the side of the block at high revs?
> Or jammed in a tight spot. Cheers, Ardun Bill
|