Dan
Does the alu strip on the door line up with the alu strip on the rear
shroud?
Even on my car, which is not restored in that area, these parts do not
line up to 100%. The shut panel lines up with the rear shroud though, IIRC.
Best regards, Per
Den 2018-02-12 kl. 23:47, skrev Corning, Dan (D.C.):
>
> Per,
>
> The original one fits much better than the new one but even that?s not
> perfect.? I?m considering ordering one from a different supplier in
> the hope it?s better.? Unfortunately, they are quite expensive.
>
> Best,
>
>
> Dan Corning
>
> *From:*Per Schoerner [mailto:per at schoerner.se]
> *Sent:* Monday, February 12, 2018 4:23 PM
> *To:* Corning, Dan (D.C.) <dcorning at ford.com>
> *Cc:* healeys at autox.team.net
> *Subject:* Re: [Healeys] BT7 Mk II Door Shut Finisher - Adjustment?
>
> Dan
>
> It looks like the shut panel can go a little bit further towards the
> center of the car, there is a gap there. On the other hand it doesn?t
> look like it will fit anyway. Do you still have the originals? So you
> can compare them.
>
> Per
>
> Skickat fr?n min iPhone
>
>
> 12 feb. 2018 kl. 20:43 skrev Corning, Dan (D.C.) <dcorning at ford.com
>
> Everything was going very smoothly installing the new Bristleflex
> door seals and lower aluminum trim set.? Too smoothly?
>
> A trial fit of the door shut finish set revealed the protrusion on
> the top is misaligned.? Anyone experienced this before?
>
> (The dotted line suggests what I?m thinking about)
>
> <IMG_0333.JPG>
>
> Best,
>
>
> Dan Corning
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180212/ca7e334f/attachment.html>
|