As I recall, and I could be wrong because it was ten years ago, I had the same
situation. The ill fitting set was from one of the usual vendors. I believe I
ordered a set from Kilmartin and they were spot on. Check with Kilmartin and
see if they sell them.
Lin
Sent from my iPad
> On Feb 12, 2018, at 5:23 PM, Per Schoerner <per at schoerner.se> wrote:
>
> Dan
> It looks like the shut panel can go a little bit further towards the center
> of the car, there is a gap there. On the other hand it doesn?t look like it
> will fit anyway. Do you still have the originals? So you can compare them.
>
> Per
>
> Skickat fr?n min iPhone
>
>> 12 feb. 2018 kl. 20:43 skrev Corning, Dan (D.C.) <dcorning at ford.com>:
>>
>> Everything was going very smoothly installing the new Bristleflex door seals
>> and lower aluminum trim set. Too smoothly?
>>
>> A trial fit of the door shut finish set revealed the protrusion on the top
>> is misaligned. Anyone experienced this before?
>>
>> (The dotted line suggests what I?m thinking about)
>>
>> <IMG_0333.JPG>
>> Best,
>>
>> Dan Corning
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/linwoodrose
> at mac.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180212/4a985b31/attachment.html>
|