I'll use that method when I re-install the pumpkin when I figure out the
problem. Thanks Dave.Mike MacLean
Sent from Yahoo Mail on Android
On Wed, Sep 27, 2017 at 6:26 PM, David Nock<healeydoc at sbcglobal.net>
wrote: Paper gaskets commonly shrink. Soak in water for a few minutes prior
to installing?
Sent from my iPhone
On Sep 27, 2017, at 5:11 PM, Michael MacLean <rrengineer.mike at att.net> wrote:
Finally installed the pumpkin in the newly painted differential case today.?
Used Hylomar to seal it.? The paper gasket from Moss did not fit very well.? I
needed to use my single hole paper punch to get it to fit.? Tightened it down
and now the output flange is locked in place.? It moves back and forth a
fraction of an inch but stops with a decided metallic clunk.? No, I did not
install it upside down.? That actually can not be done the way the ring gear is
"keyed" into the casing.? What the heck?Mike MacLean
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170928/33a08ea0/attachment.html>
|