Paper gaskets commonly shrink. Soak in water for a few minutes prior to
installing
Sent from my iPhone
> On Sep 27, 2017, at 5:11 PM, Michael MacLean <rrengineer.mike at att.net>
> wrote:
>
> Finally installed the pumpkin in the newly painted differential case today.
> Used Hylomar to seal it. The paper gasket from Moss did not fit very well.
> I needed to use my single hole paper punch to get it to fit. Tightened it
> down and now the output flange is locked in place. It moves back and forth a
> fraction of an inch but stops with a decided metallic clunk. No, I did not
> install it upside down. That actually can not be done the way the ring gear
> is "keyed" into the casing. What the heck?
> Mike MacLean
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/healeydoc
> at sbcglobal.net
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170927/d5941398/attachment.html>
|