In addition to the output flange not moving except for about an inch of
rotation back and forth both axles were slipped in place just to check
movement.? You can rotate the axle flange through complete rotation and the
opposite flange turns in the opposite direction, but the output flange does not
move.? What did I do wrong putting the pumpkin in the axle casing?? The output
shaft would turn easily while the pumpkin was out.? I know I am going to have
to take the pumpkin our again, but how did I put it in wrong?Mike MacLean
Sent from Yahoo Mail on Android
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170928/2647e346/attachment.html>
|