I don't believe you have to pay the Value Added Tax unless you live in the
UK.Mike MacLean
On Thursday, January 12, 2017 9:29 AM, Bob Spidell <bspidell at
comcast.net> wrote:
Well, I went ahead and ordered from Moss.? I did a cursory check of the
interwebs didn't turn up anything of those dimensions here:
https://www.mcmaster.com/#standard-washers/=15uvd84 and here:
http://www.keybellevilles.com/bellevilles/sampleCatalog.php?gclid=CMCHjPHOuNECFQGRfgodVAoFuA
and others, and I need to get this car back together before I start losing the
little bits.?? FWIW, SC Parts and AH Spares have them at a more reasonable
price--esp. with the current exchange rate--but with VAT and shipping it's not
a massive savings.
My thanks to Olin, Bob and others who responded; if I come across these in
this size I'll make a note for future reference.? Now, at least, I know what
they're for and how to stack them. Bob
On 1/10/2017 2:14 PM, Olin Brimberry wrote:
Bob,
I figured height of the spring was also important, so I put 2 together and
measured the height with calipers
Height of 2 washers: 0.100 inches
Height of 1 washer: 0.050 inches
Thickness of washer: 0.025 inches
Checking the previous diameter dimensions with a caliper, I get:
ID: 1.057 inches
OD: 1.5 inches
I suspect that the ID is originally spec'd to be 1-1/16" but because of the
slight "spring", the diameter is slightly less. Good luck
Olin K. Brimberry, PE
Principal Engineer
obrimberry at hunterbane.com
Office - 919.803.4274
Mobile - 919.522.1608
HunterBane Engineering, PLLC
PO Box 10314
Raleigh, NC 27605
3306 Alamance Drive
Raleigh, NC 27609
-----Original Message-----
From: Olin Brimberry [mailto:obrimberry at hunterbane.com]
Sent: Tuesday, January 10, 2017 4:34 PM
To: 'Bob Spidell' <bspidell at comcast.net>; 'Healeys' <healeys at
autox.team.net>
Subject: RE: [Healeys] Belleville washers in BN2 steering box
I just pulled mine out of a steering box I am rebuilding, and yes there are 6
positioned as such: ()()() Where only the outer edges touch. The dimensions
are as follows:
ID: 1-1/16
OD: 1-1/2
Pictures of the measurements are attached for verification purposes.
The washers were loose on the shaft, but I think the closer tolerance is going
to be on the OD side.
Olin K. Brimberry, PE
Principal Engineer
obrimberry at hunterbane.com
Office - 919.803.4274
Mobile - 919.522.1608
HunterBane Engineering, PLLC
PO Box 10314
Raleigh, NC 27605
3306 Alamance Drive
Raleigh, NC 27609
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170112/617ea854/attachment.html>
|