See correction below I forgot the 2 in 1/2"
On Thu, Feb 28, 2013 at 11:17 AM, Curtis Arndt <cnaarndt@gmail.com> wrote:
> Paul,
>
> You read something wrong. The BN1 fender distance is between 9" for the
> later BN1s and 9 3/16" to 9 1/2" for the very early BN1s. The distance on
> the BN2s is 7 1/2" making the BN2 wheel opening much larger.
>
> Cheers,
>
> Curt - AHConcours Committee
>
>
> On Wed, Feb 27, 2013 at 11:05 PM, <fiat500f@aol.com> wrote:
>
>> I need to check something. With the 100-4, there are the BN1 front
>> fenders,
>> and the BN2 front fenders. The easiest (only?) way to tell them apart is
>> to
>> measure the distance from the top of the wheel opening to the top of the
>> fender. Here is the Austin Healey service note about it.
>> http://www.acmefluid.com.au/larry/a421.jpg
>> It notes that the measured distance for the BN1 is 9 1/2 inches, and 9
>> inches
>> for the BN2. I would SWEAR it was 11 inches for the BN1 and 9 inches for
>> the
>> BN2. I just seem to have this strongly in my memory. Am I wrong? I
>> would
>> assume that the Healey service note is correct, but, dang! :)
>> - Paul B.
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>> Suggested annual donation $12.75
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>>
>> Healeys@autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
>>
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/healeys/cnaarndt@gmail.com
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|
