just did this to replace a jet assy. I removed them together till they clear
the studs--then the center section of the linkage cpmes out and suddenly you
have separate carrs. go back the same way----kinda ease the linkage in the
slots while sliding the carbs over the studs together.
Do not disasemble the linkage--you don't need to.
tom
---- Greg Mandas <gmandas@yahoo.com> wrote:
=============
Do "You" remove/install the carbs on a BJ8 together as one unit or separately?
I do them together, but it's a bit difficult to get to the two bolts under the
rear carb.
I'm assuming to replace them separately, you'd have to disassemble the linkage
and reset it afterwards.
Greg
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|