Re: [Healeys] BJ8 Carbs -- Install together or separately?

[Bob Spidell <bspidell@comcast.net>]

I've always R&R'd simultaneously. Don't think you can even do it separately, as 
the linkage is too long, even though 
it's three (I think) pieces.   You could if the carbs were bolted on, but 
they're on studs.

I reach under the front carb to get to the rear carb's lower rear nuts with a 
stubby end wrench.

Bob


On 11/26/2012 2:47 PM, Greg Mandas wrote:
> Do "You" remove/install the carbs on a BJ8 together as one unit or separately?
>
> I do them together, but it's a bit difficult to get to the two bolts under 
> the rear carb.
>
> I'm assuming to replace them separately, you'd have to disassemble the 
> linkage and reset it afterwards.
>
> Greg
>
>


-- 
*******************************************************************
Bob Spidell           San Jose, CA            bspidell@comcast.net

*******************************************************************
_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys