AFAIK, the only O-rings on the king pins are used to seal either end of the spring-loaded tubular dust cover. I think
cork washers are still used on the lower trunnion (but I haven't bought a set in years).
Any suitably-sized O-ring should work; just measure the diameter of the king pin and buy an O-ring; nitrile are best for
oily environments. They might be differently sized.
Bob
On 4/28/2012 3:40 PM, Todd Taylor wrote:
what's the O ring made out of rubber?? any idea what size?? like for
a sink??
On 4/28/2012 6:23 PM, Michael Salter wrote:
Hi Todd,
The later and currently available kits just use a standard sized O ring.
A couple of 6" sections of 3/8" threaded rod can be used to pull the
spring plate up.
--
Michael Salter
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|