what's the O ring made out of rubber?? any idea what size?? like for
a sink??
On 4/28/2012 6:23 PM, Michael Salter wrote:
> Hi Todd,
> The later and currently available kits just use a standard sized O ring.
> A couple of 6" sections of 3/8" threaded rod can be used to pull the
> spring plate up.
>
> --
> Michael Salter
>
> Check My Blog
> http://www.netbug.net/blogmichael/
>
> On Sat, Apr 28, 2012 at 6:00 PM, Todd Taylor <ttaylor33 at twcny.rr.com
> <mailto:ttaylor33 at twcny.rr.com>> wrote:
>
> wondering if there is a source for Cork washers that go on the
> neck of the king pins.
> Or is there something else I can use like nylon type. any one
> know what size they have to be??
> I hate to put an order in for 2 washers and pay $6 in shipping...
> I assume they are used to seal up grease.
>
>
> also I have to put my front springs in , any ideas to do this??
> my motor is out and there isn't any weight to work with.
> jack on the bottom will jack up the whole frame?? any specail
> tools? spring compressor wont go up the center
> because there isn't any holes to go through..
|