AFAIK, the only O-rings on the king pins are used to seal either end of the
spring-loaded tubular dust cover. I think
cork washers are still used on the lower trunnion (but I haven't bought a set
in years).
Any suitably-sized O-ring should work; just measure the diameter of the king
pin and buy an O-ring; nitrile are best for
oily environments. They might be differently sized.
Bob
On 4/28/2012 3:40 PM, Todd Taylor wrote:
> what's the O ring made out of rubber?? any idea what size?? like for
> a sink??
>
> On 4/28/2012 6:23 PM, Michael Salter wrote:
>> Hi Todd,
>> The later and currently available kits just use a standard sized O ring.
>> A couple of 6" sections of 3/8" threaded rod can be used to pull the
>> spring plate up.
>>
>> --
>> Michael Salter
>>
>>
>>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell at comcast.net
*******************************************************************
|