A sturdy four sided "box socket" will work too. Many of you purchased one
a few years back
and probably put them away and for got about them.
What was the success rate on those just out of curiosity?
Mark
----- Original Message -----
From: "Michael Salter" <msalter@precisionsportscar.com>
To: "PG" <britishcars@shaw.ca>
Cc: "Healey List" <healeys@autox.team.net>
Sent: Wednesday, February 09, 2011 4:25 PM
Subject: Re: [Healeys] Rear Axle Nut
> Correct the LH nut is a LH thread but note these are octagonal nuts, 8
> sides
> so a regular socket will not work. That is why so many are so badly
> battered!!!
>
> Michael Salter
>
> On Tue, Feb 8, 2011 at 7:05 PM, PG <britishcars@shaw.ca> wrote:
>
>> I'm trying to remove an axle nut so as to replace the seals and bearings.
>>
>>
>>
>> I have a 2 3/8" socket and try as I might, I can't get the nut to turn.
>> In
>> fact, I've damaged the but a little trying and I'm worried about rounding
>> the nut and being really screwed.
>>
>>
>>
>> I don't understand why it would be so tight or difficult to take off.
>>
>>
>>
>> Any ideas
>>
>>
>>
>>
>>
>> Paul
>> _______________________________________________
>> Healeys@autox.team.net
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation $12.75
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/healeys/msalter@precisionsportscar.com
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/lapierrem@sbcglobal.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|