Many thanks Kees,
I am just not sure I understand it all - where is the dog? Top of shaft?
Bottom?
There is a photo of the distributor on the Advanced Distributors web page:
http://tinyurl.com/2bs6nbt
Tadek
-----Original Message-----
From: Oudesluys [mailto:coudesluijs@chello.nl]
Sent: Friday, September 10, 2010 8:58 PM
To: Tadeusz Malkiewicz
Subject: Re: [Healeys] Distributor on the 100 engine
Tadek,
The offset dog on the distributor shaft should engage in a slot in the
top of the driving shaft. This slot is also off center so that it will
only engage in one position. Insert the distributor and press down
lightly, then turn the distributor shaft slowly and if all is well it
should engage at some point. You may have to lift the distributor once
or twice for succes. After that the distributor body will sink and sit
properly. Never use undue force.
Kees Oudesluijs
NL
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|