Sarah -
I think these pins may be wedge shaped. Have you tried tapping from
the opposite direction?
Alan
On 7/8/10, Carr&Edwards <scvc70@epix.net> wrote:
> We want to remove the side plate on a spare BN1 gearbox to check the
> condition
> of its internals. According to the Workshop Manual, section F/3,
> "Dismantling
> the gearbox," to remove the lever from the shaft we merely "remove nut and
> washer, tap out the pin...."
>
> Hah!!!! Nut and washer came right off; the pin has resisted tapping,
> whacking, pressure from a jury-rigged C-clamp/nut press, heating with a
> propane torch and then repeating all of the above. What do we try next???
>
>
> Gratefully,
> Sarah Carr
> BN1 in [sweltering] PA
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/healey.nut@gmail.com
>
--
Sent from my mobile device
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|