Re: [Healeys] 6 cyl + trans lift point

[Norman Nock <sjnnock@sbcglobal.net>]

Don Day ... When this engine came in the sedan there was 90 degree brackets on
the two bolts that hold the the valve cover on to lift out the engine ... you
Australians have these cars down - under   ... tell us about them ... Norman
Nock

--- On Sat, 8/8/09, Don Day <fsufan1952@yahoo.com> wrote:

From: Don Day <fsufan1952@yahoo.com>
Subject: [Healeys] 6 cyl + trans lift point
To: healeys@autox.team.net
Date: Saturday, August 8, 2009, 1:44 PM

I am in the process of lifting my motor with trans attached to insert into my
BJ-8,all body parts on,my question to the list is which bolts off the motor
should i attach the lifting bracketts to?I have seen people use the bolts that
the studs come through the valve cover to attach the valve cover down with.Has
anyone tried with good luck any other studs?

   THanks again
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

You are subscribed as sjnnock@sbcglobal.net

http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive