Scott -
You are in fact misguided. The BJ7 seat back does not fold flat, it
only comes forward a bit so that you can stow the top. The flat
platform was intorduced with the BJ8.
Regards,
Alan
'53 BN1 '64 BJ8
On 3/26/06, scott@scottjgraham.com <scott@scottjgraham.com> wrote:
> Help please - Healey listers!
>
> My rear seat back does not fold flat as I believe it should.
>
> I have just refitted out the rear seat compartment (see prior postings - had
>been converted to a hidden compartment for shipment of drugs by PO).
>
> The new rear seat panel I had made up to copy precisely an original removed
>from an old BJ7. The clips and supports I purchased from the Healey Factory &
>they seem to fit well.
>
> I was advised to use normal hardware store style hinges to connect the base
>of the seat back to the body.
>
> We used holes in the bodywork to locate and connect the rear back support
>panels. This in turn suggested the correct location of the hinges to connect
>the seat to the car - immediately behind the seats themselves.
>
> But the seat folds forward only about 5% and then fouls on the jump seats.
>
> Do I need special articulating hinges? Or am I misguided in my belieft that
>the seat back should fold flat?
|