RE: Badge Repairs

["Ron Fine" <RonFineEsq@earthlink.net>]

I first tried JB Weld.  I thought it was on tight but after installing the
badge on my car I found it hanging from the one good pin.  There is a lot of
pressure at the joint when the pin in installed through the hole in the
shroud.
Ron

-----Original Message-----
From: tom felts [mailto:tomfelts@earthlink.net]
Sent: Tuesday, January 10, 2006 5:53 AM
To: Simon Lachlan; Ron Fine; Healeys@autox.team.net
Subject: RE: Badge Repairs


A dab of JB Weld ought to do the trick.

tom