A dab of JB Weld ought to do the trick.
tom
> [Original Message]
> From: Simon Lachlan <simon.lachlan@homecall.co.uk>
> To: Ron Fine <RonFineEsq@earthlink.net>; <Healeys@autox.team.net>
> Date: 1/9/06 11:59:19 PM
> Subject: RE: Badge Repairs
>
> -----Original Message-----
> From: owner-healeys@autox.team.net [mailto:owner-healeys@autox.team.net]
On
> Behalf Of Ron Fine
> Sent: 10 January 2006 03:35
> To: Healeys@autox.team.net
> Subject: Badge Repairs
>
> Is there any practical way to attach a broken mounting pin to the rear of
a
> winged badge without destroying the front of the badge?
>
> If not, do you have any suggestions for a source of good quality after
> market badges? Compared to my original, the badges I've seen that are
sold
> by the usual vendors are fairly poor quality reproductions. I've
considered
> just using a strong double sided foam tape to glue my original in place.
Is
> this heresy?
> Ron
> BN7
>
> Plastic Metal would do it. I suppose it's available everywhere? Or its
local
> equivalent. Mixes like a body filler....paste and hardener, but onece it's
> gone off, that's it" Sets like a rock.
|