The guy who is doing the paint is a little overwhelmed by the shear
amount of grease and grim that my car has. Too keep the price from
increasing on the work, I am trying to find the best solution for
going over there and doing it myself.
Since the heat shields and wiring are going to be replaced, I would
like to steam clean it, but I don't have access to one. I have a
pressure washer, but it has lost pressure (I suspect seals are gone)
or I would use that. I might rent the steam cleaner, but would have
to see what one cost for a days rental.
Patton
On Mon, 20 Dec 2004 19:53:38 -0800, Bob Spidell <bspidell@comcast.net> wrote:
> Gunk or your favorite brand of engine degreaser (KanoLabs makes a
> good one) and warm (if possible) water. Cover the carbs and electrical
> components.
>
> Warning: a pressure washer is tempting, but it'll disintegrate the asbestos
> heat shielding on the carb shield and firewall (or so I've heard ;).
|