Ron -
www.britishcarspecialists.com are usually very good at
this sort of thing, and they are an official moss
distributor as well. Actually you're better off
ordering your Moss stuff from them rather than Moss,
to be honest. They stock ALOT of special Healey stuff
Moss doesn't carry.
Regards,
Alan
'53 BN1 '64 BJ8
--- "Ron Fine Esq." <ronfineesq@earthlink.net> wrote:
> I am looking for a source for several parts:
> 1. There is an metal backed pressed fit rubber
> oil seal at the top of the
> distributor housing. Moss shows it as part #520-280
> and NA.
>
> 2. There is a small metal piece that attaches to
> a intake manifold stud on
> the bottom end and the top end has a hold to attach
> a spring clip holding the
> water temp. capillary line. I think there are two
> of these stand off pieces,
> one at the front and one at the rear of the engine.
> Moss shows it as part
> #725020 NA.
>
> Does anyone know of a source for either of these
> items. I could fabricate the
> standoff but the seal should be available somewhere.
> If I knew the size I
> could probably get it from my local machine shop but
> getting the original out
> will certainly destroy it for measurements.
>
> Any information is always appreciated.
> Ron Fine
> 61BN7
|