Ron,
You may be looking at an old catalog. I just recently ordered and received
two distributor seals, PN 520-280 -- $5.15 each, from Moss. Can't help on
the other part.
Bob
BJ7
----- Original Message -----
From: "Ron Fine Esq." <ronfineesq@earthlink.net>
To: <healeys@autox.team.net>
Sent: Monday, April 19, 2004 9:45 AM
Subject: Looking for parts
> I am looking for a source for several parts:
> 1. There is an metal backed pressed fit rubber oil seal at the top of
the
> distributor housing. Moss shows it as part #520-280 and NA.
>
> 2. There is a small metal piece that attaches to a intake manifold stud
on
> the bottom end and the top end has a hold to attach a spring clip holding
the
> water temp. capillary line. I think there are two of these stand off
pieces,
> one at the front and one at the rear of the engine. Moss shows it as part
> #725020 NA.
>
> Does anyone know of a source for either of these items. I could fabricate
the
> standoff but the seal should be available somewhere. If I knew the size I
> could probably get it from my local machine shop but getting the original
out
> will certainly destroy it for measurements.
>
> Any information is always appreciated.
> Ron Fine
> 61BN7
|