I am looking for a source for several parts:
1. There is an metal backed pressed fit rubber oil seal at the top of the
distributor housing. Moss shows it as part #520-280 and NA.
2. There is a small metal piece that attaches to a intake manifold stud on
the bottom end and the top end has a hold to attach a spring clip holding the
water temp. capillary line. I think there are two of these stand off pieces,
one at the front and one at the rear of the engine. Moss shows it as part
#725020 NA.
Does anyone know of a source for either of these items. I could fabricate the
standoff but the seal should be available somewhere. If I knew the size I
could probably get it from my local machine shop but getting the original out
will certainly destroy it for measurements.
Any information is always appreciated.
Ron Fine
61BN7
|