Oops. TR3
> On May 9, 2016, at 11:37 PM, Joe Curry <spitlist@cox.net> wrote:
>
> It would be most helpful to know which engine?
>
>
>
> -----Original Message-----
> From: Fot [mailto:fot-bounces@autox.team.net] On Behalf Of Bill Babcock
> Sent: Monday, May 09, 2016 1:41 PM
> To: FOT Triumph
> Subject: [Fot] Front main bearing cap
>
> Anyone have one they could sell me? I'm tearing down one of peyote's engine
> and found the front cap cracked in half. It was holding the crank in fine,
> the bearing and crank look perfect, but it was broken in place. I used to
> have a spare block I could have robbed, but can't find it.
>
> I assume a good machine shop can grind the joint face bore the ting round to
> spec. Anyone done this before? Any problems or suggestions?
>
> Bill
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/fot/spitlist@cox.net
>
>
>
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/fot/bill@ponostyle.com
>
>
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|