A good rule of thumb is .005 for every 1000 rpm.
________________________________
From: Joe Boruch <jaboruch@netzero.net>
To:
toodamnfunky@comcast.net
Cc: fot@autox.team.net
Sent: Tuesday, January 22,
2013 6:38 PM
Subject: Re: [Fot] TR4 deck height
With a billet crank and
Pauter rods I use a 0.010 inch deck height, plus allow
0.022 for the head
gasket. I have run as little as 0.007 deck, but had
impressions of the head
on top of the pistons. Joe(B)
---------- Original Message ----------
From:
"Jim Gray" <toodamnfunky@comcast.net>
To: "'FoT Triumph'" <fot@autox.team.net>
Subject: [Fot] TR4 deck height
Date: Tue, 15 Jan 2013 18:27:14 -0700
Greetings FoT,
I was curious as to what the group likes to run for deck
height or piston to
head clearance
assuming forged rods and stock crank are
used.
I have heard everywhere from zero to .040
Thanks as always,
jim g
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive:
Unsubscribe:
http://autox.team.net/mailman/options/fot/jaboruch@netzero.net
____________________________________________________________
Woman is 53 But
Looks 25
Mom reveals 1 simple wrinkle trick that has angered doctors...
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive:
http://autox.team.net/mailman/options/fot/j.wags63@yahoo.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|