Impression in the carbon is just right.
Never be beaten by equipment
> From: jaboruch@netzero.net
> Date: Wed, 23 Jan 2013 00:38:35 +0000
> To: toodamnfunky@comcast.net
> CC: fot@autox.team.net
> Subject: Re: [Fot] TR4 deck height
>
> With a billet crank and Pauter rods I use a 0.010 inch deck height, plus
allow
> 0.022 for the head gasket. I have run as little as 0.007 deck, but had
> impressions of the head on top of the pistons. Joe(B)
>
> ---------- Original Message ----------
> From: "Jim Gray" <toodamnfunky@comcast.net>
> To: "'FoT Triumph'" <fot@autox.team.net>
> Subject: [Fot] TR4 deck height
> Date: Tue, 15 Jan 2013 18:27:14 -0700
>
> Greetings FoT,
>
> I was curious as to what the group likes to run for deck height or piston
to
> head clearance
>
> assuming forged rods and stock crank are used.
>
> I have heard everywhere from zero to .040
>
> Thanks as always,
>
> jim g
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/fot/jaboruch@netzero.net
>
> ____________________________________________________________
> Woman is 53 But Looks 25
> Mom reveals 1 simple wrinkle trick that has angered doctors...
> _______________________________________________
> fot@autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/kaskas@cox.net
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|