Thanks Joe, I could get this and cut it down:
http://www.mcmaster.com/#8931k91/=5beo9i
I don't think the extra pound(s) will matter.
~Steve
On Jan 10, 2010, at 10:30 AM, n197tr4@cs.com wrote:
> Look at what is available at McMaster-Carr in aluminum or bronze.
>
> OD 1.325 ID .625 Lgth 2.25
>
>
>
> -----Original Message-----
> From: Steven Belfer <colordog.1@earthlink.net>
> To: Friends of Triumph <fot@autox.team.net>
> Sent: Sun, Jan 10, 2010 12:14 pm
> Subject: [Fot] Leaf Spring Eye Bushing
>
> Anybody out there know of a Polyurethane or Aluminum bushing that
> fits the front eye of the TR3 leaf spring? (not the rear shackle kit)
> I had to take an angle grinder to the spring eye pin to get it out
> and destroyed my dad's custom aluminum bushing in the process.
>
> I'm wondering if anybody out there may know of a part number for a
> modern car (or small truck) to save me a little leg-work.
>
> I found a place that can make me a custom bushing but I'd prefer to
> find something off the shelf if possible.
>
> Dimensions: L 2.25" W 1.325 Hole: .625"
>
> By the way the replacement Stock bushing from Moss does not fit onto
> their new pin.
>
> ~Steve
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> Suggested annual donation $12.96
>
> You are subscribed as n197tr4@cs.com
>
> http://www.fot-racing.com
>
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
> Brought to you by Team.Net consulting - Unix software specialist.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.96
http://www.fot-racing.com
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
Brought to you by Team.Net consulting - Unix software specialist.
|