Yikes! I didn't know there were any markings! While it is up on the
stands, I will certainly look - mine still has the rubber boot over the
shaft...is it under that?
Thanks!
On 9/1/2010 6:01 PM, Bill Cole wrote:
> Mark, Unless you can locate the splined yoke's alignment mark through
> the shifter hole, I would remove the driveline and yoke and match up
> the all "0" stamp marks that they have on them , they are not easy to
> see but they are there. Your driveline could still be 180 degrees off
> from where it originally was if you do not know where the "0" is
> located on the splined yoke, hope this helps... Bill
________________________________________
Datsun-roadsters@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $16.00
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|