After I sent my first reply to this thread I started thinking about a
tool that could be inserted into the water passage that could push on
the sender straight, instead of at an angle. How about two arms with a
fulcrum in the middle that could be inserted into the top of the head,
bear against the inside of the water passage, and the other arm press
against the sender? Put a bolt through the top ends of the arms, or use
a clamp to put linear pressure onto the sender.
Peace,
Pat
Thusly spake dave:
> Linda,
> I would look for new mechanics. Re-reading the 311's thread, the one
> who wanted to burn it out is particularly scary, or just
> lying...Aluminum heads and oxy-acetylene torches don't play well
> together. BTW, How did you finally get yours out?
>
> Anyway you get it out, anti-seize is needed when reinstalling, so you
> don't need to do it again.
>
> Dave Brisco
> EastCoastRoadster.com
>
> -----Original Message-----
> From: ljordan704@netscape.net [mailto:ljordan704@netscape.net]
>
> As discussed on 311 site:
> http://www.311s.org/phpBB3/viewtopic.php?f=3&t=6426&start=0&st=0&sk=t&sd
> =a&hilit=temp+and+sender
>
>
> If head is still on car it can be damaged. No mechanics would attempt to
> remove sender without removing the head first when I checked.
>
> Linda
>
>
>
>
>
>
>
>
>
>
>
>
>
>> I've been trying to get a temp sensor out intact and have managed to
>>
> trash
> a
>
>> couple... is there a secret? or just one of those dissimilar metals
>>
> reactions
>
>> and I'm screwed....not a problem getting the "sleeve" off, just
>>
> removing
> the
>
>> brass sensor
>>
>> Thanks-
>> Craig
>> ________________________________________
>> Support Team.Net http://www.team.net/donate.html
>>
>> You are subscribed as pat@hornesystemstx.com
>>
>> Datsun-roadsters mailing list
>>
>> http://www.team.net/archive
>>
>> http://autox.team.net/mailman/listinfo/datsun-roadsters
>>
>>
>> No virus found in this incoming message.
>> Checked by AVG - http://www.avg.com
>> Version: 8.0.138 / Virus Database: 270.5.3/1564 - Release Date:
>>
> 7/21/2008
> 6:42 AM
>
>>
>>
>>
>
>
--
Pat Horne, Owner, Horne Systems
(512) 797-7501 Voice 5026 FM 2001
Pat@HorneSystemsTx.com Lockhart, TX 78644-4443
www.hornesystemstx.com
-- We support Habitat for Humanity - a hand UP, not a hand OUT --
________________________________________
Support Team.Net http://www.team.net/donate.html
Datsun-roadsters mailing list
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/datsun-roadsters
|