datsun-roadsters
[Top] [All Lists]

Beauty & Beast EI Distributors Round 2 - Plus

To: Datsun Roadsters <datsun-roadsters@autox.team.net>
Subject: Beauty & Beast EI Distributors Round 2 - Plus
From: Gary Boone <gboone@sisna.com>
Date: Wed, 11 Jun 2003 19:24:19 -0600
Hello Roadster folks,
I have another 2 electronic distributors ready to go, in their rare 
form.  But first of all, I'd like to mention that, after over 21 months 
of being unemployed, I finally have a job starting next week.  I'm 
looking forward to being an engineer again.  The reason I mention this 
that I want to express my sincere gratitude to all those who have 
purchased electronic distributors from me.  I thank you very much, as it 
has kept me out of the nut house during my long term of unemployment. 
I'll still make the EI distributors for anyone, but just may not be as 
fast getting them out as I was previously.  I'll also still support any 
problems, questions, or warranty work.

If you wish to view a photo of the Beauty & the Beast electronic 
distributors for Round 2, there is one on my picture trail site at:
http://www.picturetrail.com/  
Enter gboone in the member name under "Visit Album".  It's the first 
photo in "My Automobiles" album.

The "Beauty" distributor is built from an unusually clean housing and 
I've polished it.  It looks better than new and is suitable for a show 
car.  It comes with a new cap and rotor just like all my others (except 
the Beast).  It's price is $240 plus $25 core charge and shipping.  This 
price is only $10 over the normal price.  I can remove the vacuum 
controller for no vacuum advance for a Solex car and you can deduct $35 
from its price.

The "Beast", on the other hand, is fairly ugly, but not nearly as bad as 
the first Beast.  It's price is $99 plus $25 core charge and shipping. 
 That's less than the cost of a new points distributor.  The only 
problem with the Beast is cosmetic.  It comes with a used cap and rotor, 
but they are in very good condition.  

With both of these distributors, I'll throw in for free, a used Nissan 
12 volt EI coil and mounting bracket.  They are tested and painted to 
look nice but a show car would need a new coil.  I can provide a Nissan 
part #, or info for you to get a high performance aftermarket coil on 
your own.

To express my thanks, if anyone who has previously purchased a 
distributor from me , I'll deduct $25 from their price on either 
distributor.

It's first come, first serve, and if they don't sell by Monday noon MDT, 
they both go to eBay.

Thanks,
Gary Boone   

///  datsun-roadsters@autox.team.net mailing list
///  Archives at http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>