hi,
im ready to tune up the engine again after replacing the Dizzy (first time I
get to use the slang term for it! hehhe). anyway, the book I have has a
small blurp about adjusting the clearance between the push rods (they ride
on the lobes) and the rockers. but that is all it says. do I move the screw
out until I can get the gauge in there and then tighten until it drags a
little? or is it set by the gap between he bottom of the rocker and the top
lip of the rod? I hope this makes sense.
thx,
mike
/// datsun-roadsters@autox.team.net mailing list
|