My experience with putting a top on can be seen at the following URL:
http://home.texoma.net/~sitsinwest/top.htm
Best regards,
Fred Schroeder
'70 2000
SRL311-13359
TDROC
Home page http://home.texoma.net/~sitsinwest/
----- Original Message -----
From: "linob" <lino.baggio@idxcorporation.ca>
To: "'datsun list'" <datsun-roadsters@autox.team.net>
Sent: Tuesday, June 25, 2002 11:16 AM
Subject: Convertible top
> Hi List,
> Need some advice - my recent roadster purchase netted a brand new
> convertible top, mounted to a 'like new' frame, ready to be installed on
> the car with the exception of lower hardware for the lift the dot
> fasteners and eyelets have yet to be attached to the material. The car
> body has all the receiving hardware where it should be. I was also
> fortunate to get an older, used top mounted on a frame to use as a
> guide. We're finally into summer here in sunny southern Ontario and it's
> warm enough to have the top material loosen up in the sun so that it can
> be properly stretched to fit the car. I'm a little intimidated with
> cutting into a brand new top or having it fit loosely when I'm done -
> any pointers from those that have done it before would be appreciated.
>
> Thanks in advance...
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
|