Rich,
That should be a metric master. You'll need adapters to get the brake lines
to fit correctly.
Mike
----- Original Message -----
From: "Richard Wright" <duntov1@attbi.com>
To: <datsun-roadsters@autox.team.net>
Sent: Monday, December 24, 2001 5:30 AM
Subject: Re: brake master 2000
> The reason I asked about the brake master is because I found a near direct
> bolt in master cylinder for $40!
> I just installed a 1972 620 Datsun truck brake master from O'Reiley's auto
> parts, using the original 2000 reservoirs. The bore is 3/4, as cast into
> both the masters on the side. The brake lines point down, but with a
little
> different spacing.
>
> You just half to start the brake lines before you install the master the
> rest of the way!
>
> Rich W
> Dallas
> ----- Original Message -----
> From: "Adam Bradley" <ambradley@yahoo.com>
> To: "Richard Wright" <duntov1@attbi.com>
> Sent: Sunday, December 23, 2001 8:57 PM
> Subject: Re: brake master 2000
>
>
> > I don't know the bore, but 68-70 1600 and 2000 use the same master
> > cylinder.
> >
> > The clutch and brake pedal should sit at the same height. Look under
> > your dash and see if one of the pedal stops is bent back. You may have
> > an aftermarket clutch master cylinder that has a threaded rod and
> > clevis. It may be adjusted too high, and the pedal stop may be bent
> > back to stop it from constantly depressing the clutch pedal (partially
> > engaged clutch).
> >
> > --- Richard Wright <duntov1@attbi.com> wrote:
> > > Is the brake master bore 3/4" on a 2000?
> > > Does the brake pedal sit low like the gas pedal, or up higher up like
> > > the
> > > clutch?
> > > Rich W
> > > Dallas
> > >
> > > /// datsun-roadsters@autox.team.net mailing list
> > > /// Send admin requests to majordomo@autox.team.net or go to
> > > /// http://www.team.net/cgi-bin/majorcool
> > > /// Send list postings to datsun-roadsters@autox.team.net
> > >
> >
> >
> > =====
> > Adam
> > '70 1600 SPL311-28181
> > http://www.picturetrail.com/abend
> > Send your FREE holiday greetings online!
> > http://greetings.yahoo.com
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
|