Daniel Neuman wrote
> I plan on cutting out the inner fender in the carb area to clear the air
>box. Todd thinks that I should just run the intake tube along the inside
>of the
>fender to the front of the car.
This is a good start! now remove the left headlight and install a terry
cost traffic cone induction system in the headlight hole, ducting the air
to the stacks. For a second headlight you'll need to wear a miner's
helmet. Should work great! ;-)
> I plan on carving up some foam and using it as a buck to lay some
>fiberglass on and then desolving out the foam with acetone. This way I can
>have
>all kinds of crazy shapes and don't ahve to worry about getting the buck
>out of
>the fiberglass
On a serious note, polyester resin will melt styrofoam before you have a
chance to use the acetone on it. Epoxy resin is another matter. You
could wirebrush the styrofoam out of the part easily and not have a
puddle of toxic goo to deal with.
-Marc T.
==========================================================================
Marc Tyler
Designer,
Animal Firm
830-324-6578
www.animalfirm.com
|