They friction weld the axle shafts after cutting them?
They want a lot more than $240.- where I live to shorten
a solid rear axle so I'm using an IRS instead.
Thomas
the Swede
DemonTSi@aol.com wrote:
> In a message dated 09/16/2000 1:50:30 PM Pacific Daylight Time,
> csp311@telia.com writes:
>
> > And the earlier RX-7 probably had the early 4x110mm bolt patten.
>
> That is correct, and so did the GSL rear ends, which also came with LSD and
> disk brakes. BUT, their rear rotors are solid, not vented. So if anyone goes
> yarding for a GSL-SE rear end, make sure you pull the rear end that has the
> VENTED rear brakes!!
> BTW, cost to shorten the housing and axles should be no more than 200-240
> bucks...
>
> \/ /\ /\/
> www.sr20parts.com
|