In a message dated 6/5/00 7:33:42 AM Pacific Daylight Time,
Mark_Kalmus@dell.com writes:
<< I am wanting to turn the engine
manually to put in a new set of points but can't seem to get at the main
pulley bolt using my 12-inch crescent wrench (even after pulling the fan and
shroud). I tried using a 1" socket, but the bolt is larger. Anyone know
what size the bolt is? Is there a trick to getting a grip on it with a
wrench? >>
Hello,
Why not just put the car in 4th gear and push it forward until you get the
distributor lined up on the high point. Is there anything wrong with that
procedure?
Michael "Calspeed" Carion
67.5 SRL311-000248 Solex
|