Morning List,
Just started to reassemble my 2 liter. I have a few questions.
First should the crank be hard to turn over after turning the crank and
putting new bearings in it. I plasti-gaged it and it was in tolerance. I
also cleaned and used assembly lube on bearings before I final torqued
the main caps. The crank can not be rotated by hand it needs a socket
and ratchet to turn it over. It has been 25 years since I rebuilt the
low
end of an engine. I just want to verify things as I go along.
Mike
SRL 311 11714 is coming back to life!!
There is a heat wave here in Idaho! Its in the sixties, and sunny.
|