Jim,
Thanks. I slipped on that one as it has been ages since I have had
a 1600 (uh, 8 years). I was thinking it was an 8mm stud, but
10mm makes more sense.
Cheers,
Tom
>From: Jim Tyler <jtyler29@idt.net>
>
>Nah, they are 10mm (late) or 3/8 (early). 25-30 ft-lbs is about right.
>I use 25-27 for the aluminum heads.
>Never seen any issue with these numbers unless YOU screw up and overtorque
>them and pull out the threads in the aluminum....far too commonly done!
>
>Jim Tyler (I'm baaack...)
>
>----------
>From: Thomas Walter[SMTP:walter@omni.sps.mot.com]
>
>>It doesn't mention the torque for the 4 nuts that hold
>>the Rocker Assembly to the head. Can someone fill me in?
>
>If I remember they are about 5/16" bolts (or 8mm on metric heads).
>14 to 18 ft-lbs would be about the torque.
>
|