Roger,
I have not been following your saga too closely, but sounds like something I
went through about a year ago.
In my case, I rebuilt the carbs, SU's and reset the valves after
removing the head, new plugs , points , you know all the right stuff.
After I was positive I did it all corret, the little bugger wouldt not start.
I figured that I must of done something wrong and proceeded to take
everything apart and do it all over again.
I did this three times and in the end I found out that I have made one minor
mistake in the very beginning of the process.
I neglected to torque the head down properly. The manual I had was wrong and
when I decided to buy a new head gasket, my parts guru couldn't figure out
why I needed one so soon. After some discussion, we figured it out . Once I
torqued the head properly, the little bugger started on the first push of the
starter.
And has run just great ever since.
Good luck, I hope your problem is no more complicated than mine>
Chuck Centore
TR3 61@AOL.COM
Have you Checked your head today?
|