Robert:
-> The problem is that the bolts, unlike those on the TR-6, go into welded
-> on nuts in the radiator, not the frame. And they have to go in from
-> underneath. But the path from underneath is blocked by the front frame
-> crossmember...
-> Solution: Drill a hole big enough to get an extension through @ point
-> marked
I too puzzled over this problem, and was finally able to remove the horizontal
bolts holding the frame crossmember to the frame (the bolts were frozen
inside the frame sleeve. Once the crossmember is dropped, you have easy
access to the bolts from below.
Regards,
Michel
|